Description: Impact crusher is a new type of high efficient crushing equipment, which is characterized by small size, simple structure, big crushing ratio, low energy consumption, large production capacity, uniform product size, and selective crushing effect. In the impact crusher working, the operator on the machine maintenance is particularly important. Because impact crusher is broken by the impact of the material directly, it has very strong wear. So customers should pay attention to the attentions of impact crusher maintenance.
Before driving, the equipments should conduct strict examination. Bolt fastening parts whether is loose, wear parts whether are excessive wear. Discover the problems, and to solve it. In addition, check the position of the equipment noise, temperature, vibration, and so on. Keep impact crusher is in normal operation.
When driving, it should start driving in accordance with the impact crusher mahine system equipment. When parking, it should also be parking in accordance with the provisions of the parking order.
In impact crusher normal operation, we should always check the lubrication system. Add lubricating oil and lubricating oil new periodic replacement in time. Rotor bearing temperature, normally should not exceed 60 ℃, and shall not exceed a maximum of 75 ℃. If temperature is higher than this limit, it should be stopped immediately, and take effective measures to deal with.
Impact crusher feeding should be uniform, in order to prevent more than bulk materials required and non-broken material into the machine. If found abnormal phenomenon (abnormal vibration and noise), it should stop to check, and find out the reasons and troubleshooting rear drive.p>
Plate hammer wear should be timely replacement. Change must be on the new board hammer weighing to choose, making sure the rotor static balance better.
The inner wall of the casing protection plate, back plate and bolt severe wear should be promptly replaced. In order to prevent the lining plate and the back plate off caused a serious accident.
The machine has a strong impact on operation of the crusher, and the dust generated by larger, so the crusher plant shall be strictly sealed and good ventilation and dust work.
The gap size between impact plate and plate hammer has a great influence on the product size. It should be kept in the specified range, and can be adjusted according to the nature of the materials and product size requirements.